Searches

How to build an aquarium

How to build an aquarium


We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Building an aquariumdo-it-yourself" it is a rewarding project that can give a lot of satisfaction. In this article we will explain how to build an aquarium with four simple steps.

If you decide to build an aquarium we do not recommend setting up the marine one, especially if it is your first experience. The marine aquarium involves constant dedication and maintenance, and also has a very high cost due to the complex management of the salinity of the water and for the more expensive and delicate fish, therefore more in need of care.

We recommend starting with a freshwater aquarium not too big, to become familiar with theaquariology, better learn a build an aquarium that all the maintenance phases can be managed. At most, you can choose a standard tank with a capacity of 250 liters and a size of 100X50X50 cm.

Material needed for the construction of an aquarium:

  • Two plates, front and rear (100X50X1 cm), two side plates (48X49X1 cm) and a bottom plate (100X48X1 cm). Previously cut in the glass factory.
  • Acetone.
  • A 100% non-toxic silicone sealant.
  • A roll of blotting paper.
  • Filter complete with pump and sponge.
  • Timer for switching on the lights.
  • Lamps with 11 W bulbs.
  • Carbon dioxide plant with canister.
  • Brown pumice.
  • River sand.
  • Bag of aquarium bottom material.
  • Fossilized woods.
  • Stones.
  • Aquarium plants.

Building an aquarium, first phase.
Tank construction:

Before placing the sheets, it is essential to clean and degrease the glass that must be glued. For this reason it is advisable to use acetone which, in addition to cleaning, degreases the glass surfaces. Without absolutely touching the clean surfaces with the fingertips of your hands, you can position the glasses and glue them with silicone.

Place the bottom plate on a completely dry surface, consequently position the side and front windows vertically without burdening the bottom glass with the help of the square.

When the plates are correctly positioned, the glasses will be glued with silicone, helping us with the gun and taking care not to leave air bubbles between the two glasses.

Allow the silicone to dry for 24 hours. Subsequently, remove with a razor blade or acetone, the excess on the outside and inside of the gluing.

Building an aquarium, second phase.
Preparation of the tub

We proceed with the assembly of the lamps first. Subsequently, the bottom will be set up with bottom material, brown pumice and river sand. Finally, arrangement of the carbon dioxide system and preparation of the filter.

Building an aquarium, third phase.
Planting

Wet the bottom with at least 5 centimeters of water and arrange the plants to your liking. Tall, fast growing plants will be placed in the back.

While on the other hand, as regards the lateral parts of the tank, these areas must be occupied by medium-sized vegetables with large leaves. Finally, the front of theaquarium it will be reserved for all those plants or rather small seedlings that grow slowly and do not obstruct the view. Then fill the aquarium with water while maintaining a constant temperature of 25 degrees and a constant supply of carbon dioxide.

Building an aquarium, fourth phase.
Fish accommodation

Wait at least a week for those microorganisms for the life of the fish to form in the filter. Finally, finally settle your aquatic guests.

You might also be interested in

Sea tomato: recipes



Video: DIY Stream aquarium build. (July 2022).


Comments:

  1. Clust

    Nothing special

  2. Barton

    SPSB

  3. Yojind

    Wonderful, this valuable information

  4. Mac Ghille-Dhuinn

    ok movie?



Write a message